With so many on offer these days, it is great to have a name you can trust. This item is certainly that and will be a perfect buy. The distributor have added some great touches and this equals great value.
You can trust this review, i hope you can try to buy this product and then you know this product good or no. Next time you can make a review for another people.
The only low cost LVLP sprayer around
I researched many HVLP and LVLP sprayers before buying this because I have a small air compressor with only 1.5 Gallon storage capacity and 3CFM at 40psi. Many discussion groups simply tell you that with such a small compressor and low CFM, you can not hope to get good atomization and spray results with any type of gun. But having used this LVLP 1.3mm gun (I have yet to use the 1.7mm nozzle), I was really amazed at the quality of the spray at just 20 PSI setting at the gun inlet with trigger fully pulled and spray pattern set to circular (but 65 PSI setting at compressor). It needs about 25 PSI if you adjust the spray pattern to fan-shaped because some air has to be diverted to shape the spray beam through the nozzle horns. The design of the gun gives you very fine control of the air volume, paint density and spray patterns. If you compare this design with some of the most expensive IWATA guns (e.g. http://store.summitracing.com/partdetail.asp?part=ast-39570) , they are similar-...
Click here to read the full review for more information about this product.
Good spray guns for the price
A6034 is priced low but still provides good quality spray like more expensive units. Sprayer nozziles are 1.3 mm and 1.7 mm, which can produce good quality paint.
It sprays polyurathane, stains, and all types of oil-based finish materials without having any trouble. The output quality is fairly good.
I used 1.3mm nozzle to spray urethane for bookcase finish. I could spray the stain easily and achive the very consistent output. Also I sprayed the final finish and its surface is silky smooth. That is the point I'm happy for the purchase of this gun set.
The entire finish process for bookcase was much faster than brush painting, took less than 1/10 of time. Also it uses very small amout of paint. Due to lvlp, it saves a lot of materials.
Clean up was easy too. Just pour mineral spirit a little in the cup, rinse it, and spray through the gun. It cleans up real easy. I've used this gun more than 10 times now, so far have no problem using this way...
Great Value for Aspiring Wood Finishers
I've been holding off purchase of an HVLP spray set up for two reasons. Fisrt, the gravity systems have required 8 to 12 CFM airflow to operate properly and two, the turbine systems are yet another item to store in an already overcrowded garage / workshop.
These guns operate nicely on 3 to 4 cfm at 30psi and they works great with my 3 gal shop compressor, even on larger furniture. I've been spraying two coats of General Finishes Milk Paint followed by wipe on Glaze with two or three coats of Water Based Poly (General Finishes). The 1.7mm tip provides a well atomized, easy to control coat with these products. I had one older can of paint that required a little thinning but otherwise I've sprayed right out of the can. These are very nice finishes and readily available.
Cleaning is easy, especially if you go buy the disposable gravity cups from Harbor Freight ($6.99 for several). I just dump out excess paint, flush out with a spray of water and take it to the...
Product Features :
- Low volume, low pressure, uses a lower volume of air with operating pressure of 15 - 45 PSI
- Spray pattern 7-to-11-inches
- Precision machined air cap set
- Color coded needle and nozzle for easy identification
- Both guns feature 1 liter aluminum paint cup
Rating : 4.6
List Price : $119.99
